Manufacturer of forged products, scaffolding parts, logistics equipment,
listed on the 1st section of the Tokyo Stock Exchange.
Our forging press is equipped with an automatic forging roll machine that effectively improves the material yield ratio. This 4,000-ton press has a wide and long stroke specification, so it is capable of forging components of complex geometry or parts with deep holes.
In-house facilities:
- 4,000-ton press (2 units)
- 3,000-ton press (2 units)
- 4,000-ton press (2 units)
- 3,000-ton press (2 units)
Main parts:
- Tube
- Knuckle spindle
- Connecting rod
- Pinion
- Spline yoke
- Joint yoke
Forging parts made using a 4,000-ton press
Forging parts made using a 3,000-ton press
When combined with a free hammer or upset forging machine, an air drop hammer is capable of forging large connecting rods or large axle shafts.
In-house facilities:
- 10-ton hammer (1 unit)
- 6-ton hammer (1 unit)
- 3-ton hammer (1 unit)
- 10-ton hammer (1 unit)
- 6-ton hammer (1 unit)
- 3-ton hammer (1 unit)
Main parts:
- Camshaft
- Connecting rod
- Axle shaft
- Arm
- Master link
- Flange
Parts forged using a 6-ton air drop hammer
Parts forged using a 3-ton air drop hammer
This series of facilities from 6-inch to 9-inch upset forging machines enables us to handle a variety of parts from small to large sizes. This is the optimal forging machine for shafts, and is also able to forge pipes and other parts.
In-house facilities:
- 9-inch upset forging machine (1 unit)
- 7.5-inch upset forging machine (1 unit)
- 6-inch upset forging machine (1 unit)
- 9-inch upset forging machine (1 unit)
- 7.5-inch upset forging machine (1 unit)
- 6-inch upset forging machine (1 unit)
Main parts:
- Axle shaft
- Main shaft
- Gear main shaft
- Pinion
Parts forged using a 9-inch and 7.5-inch upset forging machine
Parts forged using a 6-inch upset forging machine
